nao sei se na tua é assim mas posso tentar ver .
maxster e majesty é assim:
OIL INDICATOR LIGHT
• FUNCTION
Pulses (travel distance signals) from the speedometer are counted and cause the oil indicator light
to come on at 500 km for the first time and thereafter every 3,000 km. In this way, the light indicates
the time for oil change.
• RESETTING PROCEDURE
To reset the oil change indicator light
1) Press the “TRIP” button while turning the key to “ON”.
2) Release the button and the oil change indicator light will go off.
NOTE:
To reset the oil change indicator light before the periodic oil change interval has been reached, follow
the above procedure.
ODOMETER/TRIPMETER READING MODE
The odometer and tripmeter can be set to count in either miles or kilometers according to the following
procedure.
1) Turn the key to “ON”.
2) Press the “TRIP” button until the current mode appears in the dispaly:
“CONT” (continental) for kilometer mode and “EnGL” (English) for the mile mode.
3) Press the “TRIP” button to switch mode.
4) Press the “TRIP” button for two seconds to confirm the setting.
NOTE:
• The odometer/tripmeter reading mode can be changed any number of times while the odometer
reading is below 10, but it cannot changed anymore after the reading has reached 10.
•Switching between the mile and the kilometer mode does not change or convert the current odometer/
tripmeter reading.
BATTERY VOLTAGE/FUEL GAUGE
When the key is turned to “OFF”, the voltage/fuel gauge indicates the battery voltage.
NOTE:
If the battery voltage drops to 10V, refer to “CHECKING THE BATTERY” section in chapter 3.
When the key is turned to “ON”, the voltage/fuel gauge indicates the amount of fuel in the fuel tank
after indicating the battery voltage for two seconds.
